eSUN PLA+
Tougher than standard PLA; good for prints that take occasional knocks
Listed values and ratings are starting points, not verified test results. Formulations, prices, test methods and printer settings vary. Confirm details on the manufacturer page below.
Food-contact suitability cannot be determined from material type alone. Check the exact product's manufacturer guidance and the finished part's intended use.
Where it shines
Tougher than standard PLA; good for prints that take occasional knocks.
Common use cases: prototyping, indoor-mechanical-light, fine-detail.
Where it falls short
Still PLA underneath — heat-sensitive, indoor only.
Print profile starting point
- Nozzle temp: start at 215°C and tune ±5°C for surface finish.
- Bed temp: 50°C is usually enough for adhesion; go up toward 60°C if first layer struggles.
We link directly to the manufacturer where possible. Some retailer links may be affiliate links; we only ever link to products we'd recommend regardless.
Compare materials, learn about storage and printing, or return to the filament database.