eSUN eTPU-95A
Reliable, beginner-friendly flexible filament — squishy enough to be useful, firm enough to print
Listed values and ratings are starting points, not verified test results. Formulations, prices, test methods and printer settings vary. Confirm details on the manufacturer page below.
Food-contact suitability cannot be determined from material type alone. Check the exact product's manufacturer guidance and the finished part's intended use.
Where it shines
Reliable, beginner-friendly flexible filament — squishy enough to be useful, firm enough to print.
Common use cases: flexible, phone-cases, vibration-damping, wearables.
Where it falls short
Slow print speeds required; bowden setups struggle.
Print profile starting point
- Nozzle temp: start at 230°C and tune ±5°C for surface finish.
- Bed temp: 40°C is usually enough for adhesion; go up toward 60°C if first layer struggles.
- Drying: 60°C for 6 hours is a listed starting point; follow the current manufacturer guidance for your spool and dryer.
- Print speed: keep below 30 mm/s for clean walls; bowden setups will prefer the slower end.
We link directly to the manufacturer where possible. Some retailer links may be affiliate links; we only ever link to products we'd recommend regardless.
Compare materials, learn about storage and printing, or return to the filament database.