Hatchbox Hatchbox ABS
Classic ABS for higher-temp parts; smooths beautifully with acetone vapor
Listed values and ratings are starting points, not verified test results. Formulations, prices, test methods and printer settings vary. Confirm details on the manufacturer page below.
Food-contact suitability cannot be determined from material type alone. Check the exact product's manufacturer guidance and the finished part's intended use.
Printing can release harmful gases and particles. Bambu Lab warns that its ASA may release gases including styrene; use effective ventilation or exhaust, and consult the manufacturer's safety tips and NIOSH guidance. An enclosure alone does not establish adequate ventilation.
Where it shines
Classic ABS for higher-temp parts; smooths beautifully with acetone vapor.
Common use cases: structural, high-temp, post-processable.
Where it falls short
Warps badly without enclosure; emits styrene during printing.
Print profile starting point
- Nozzle temp: start at 225°C and tune ±5°C for surface finish.
- Bed temp: 90°C is usually enough for adhesion; go up toward 110°C if first layer struggles.
- Drying: 65°C for 4 hours is a listed starting point; follow the current manufacturer guidance for your spool and dryer.
- Enclosure: may help reduce warping; follow the manufacturer's guidance. An enclosure does not replace ventilation.
We link directly to the manufacturer where possible. Some retailer links may be affiliate links; we only ever link to products we'd recommend regardless.
Compare materials, learn about storage and printing, or return to the filament database.