Polymaker PolyMax PC
High-impact, high-heat structural prints — toughest non-nylon you'll print at home
Listed values and ratings are starting points, not verified test results. Formulations, prices, test methods and printer settings vary. Confirm details on the manufacturer page below.
Food-contact suitability cannot be determined from material type alone. Check the exact product's manufacturer guidance and the finished part's intended use.
Where it shines
High-impact, high-heat structural prints — toughest non-nylon you'll print at home.
Common use cases: structural, outdoor, high-temp, engineering.
Where it falls short
Needs enclosed printer; absorbs water aggressively.
Print profile starting point
- Nozzle temp: start at 260°C and tune ±5°C for surface finish.
- Bed temp: 90°C is usually enough for adhesion; go up toward 105°C if first layer struggles.
- Drying: 80°C for 8 hours is a listed starting point; follow the current manufacturer guidance for your spool and dryer.
- Enclosure: may help reduce warping; follow the manufacturer's guidance. An enclosure does not replace ventilation.
We link directly to the manufacturer where possible. Some retailer links may be affiliate links; we only ever link to products we'd recommend regardless.
Compare materials, learn about storage and printing, or return to the filament database.