Prusa Prusament PETG
Reliable PETG with consistent layer adhesion; great for outdoor brackets
Listed values and ratings are starting points, not verified test results. Formulations, prices, test methods and printer settings vary. Confirm details on the manufacturer page below.
The listed elongation at break is unavailable: Prusa's technical data sheet reports elongation at yield for specific printed specimens, not elongation at break.
Food-contact suitability cannot be determined from material type alone. Check the exact product's manufacturer guidance and the finished part's intended use.
Where it shines
Reliable PETG with consistent layer adhesion; great for outdoor brackets.
Common use cases: outdoor, structural.
Where it falls short
Stringy without retraction tuning; absorbs moisture quickly.
Print profile starting point
- Nozzle temp: start at 245°C and tune ±5°C for surface finish.
- Bed temp: 80°C is usually enough for adhesion; go up toward 90°C if first layer struggles.
- Drying: 65°C for 6 hours is a listed starting point; follow the current manufacturer guidance for your spool and dryer.
We link directly to the manufacturer where possible. Some retailer links may be affiliate links; we only ever link to products we'd recommend regardless.
Compare materials, learn about storage and printing, or return to the filament database.